Troubleshooting - Tallahassee, FL

Garage Door Won't Close or Keeps Reversing? Tallahassee Repair

Why a garage door starts down and then goes back up, what you can safely check, and when to call.

✅ Mobile Service to Your Door ✅ Written Quote First ✅ Upfront Pricing ✅ Safety Check Before We Leave
What's Happening

Why Your Garage Door Reverses Before It Closes

When a door starts down and then reverses, the opener is doing its job. It thinks something is in the way, or it cannot tell where the floor is. The cause is usually one of four things: the safety sensors, the opener's force or travel settings, a door that is out of balance, or something stuck in the tracks.

Work through the checks below in order. None of them involve the springs or cables, which should only be handled by a technician.

Safe Checks

Checks to Try Before You Call

1. Look at the photo-eye lights

Two small sensors sit near the floor on each side of the door. Under the UL 325 safety standard they are mounted no more than 6 inches above the floor. Both lights should be steady. If one blinks or is dark, the eyes are misaligned or blocked.

2. Wipe the lenses and clear the beam

Dirt, a spider web, pollen or a box left near the door can break the beam. Wipe both lenses with a soft cloth. After a windy storm, leaves and debris often collect right where the sensors sit.

3. Check the tracks

Look for debris, dents or a roller that is stuck. Wipe dirt out of the tracks. Do not lubricate the inside of the track.

4. Test the door by hand

Pull the red emergency release cord and lift the door yourself. If it feels heavy, sticks or drops, the door is out of balance. Stop here and call, because that is a spring or cable problem.

5. Read the opener light

Many openers flash a diagnostic code. On Chamberlain and LiftMaster models, five blinks points to the RPM sensor. Your manual lists the other codes.

6. Force and travel limits

If the force setting is too low, the opener reverses at the slightest resistance. Wrong travel limits can make it reverse at the floor. Adjust these only as your manual describes, and only on a door that balances by hand.

Stop and Call

When to Stop and Call a Technician

Call if the door feels heavy by hand, hangs crooked, has a frayed cable, made a loud bang, or still reverses with clean, steady sensors. Do not tape over or disconnect the sensors to force the door shut. They are what stops the door from closing on a person, a pet or a car. For the repair side, see our sensor, remote and keypad repair page.

FAQ

Garage Door Won’t Close: Common Questions

The opener thinks something is blocking the door. The usual causes are misaligned or dirty photo eyes, a force or travel setting that is off, an object in the tracks, or a door that is out of balance.

A blinking light on the opener or on a sensor often means the photo eyes are misaligned or the beam is blocked. Clean both lenses and check that both sensor lights stay steady. If they do and the door still will not close, call us.

Pull the red emergency release cord and lower the door by hand only if it moves freely. If it feels heavy or drops, do not force it, because a spring may have failed.

No. The sensors are a safety feature required on residential openers. Disabling them can let the door close on a person or a pet.

It depends on the cause. A sensor adjustment costs far less than a spring repair. You get a written quote before work starts, and our cost guide shows typical ranges.

Door still will not close?

Call and tell us what the opener and the sensor lights are doing. We will tell you the likely cause before anyone drives out.

Call (850) 739-7022
📞 Call (850) 739-7022