Wind-Rated Garage Doors in Tallahassee: What the Rating Means
How wind ratings work, how the right one is chosen for your home, and what to ask before you buy.
What a Wind-Load Rating Is
A garage door's wind-load rating is its design pressure, measured in pounds per square foot. According to Clopay, the door's rating must equal or exceed the design pressure required for the opening where it will be installed. The pressure has both a positive value, for wind pushing in, and a negative value, for suction pulling out.
A bigger, wider door catches more wind, so the same home can need a different rating for a two-car door than for a single.
What Decides the Rating Your Home Needs
Wind speed for your location
The minimum design wind speed for your address, and whether your home falls in a wind-borne debris region.
Exposure category
Exposure B covers urban, suburban and wooded terrain. Exposure C is open terrain. Exposure D is within 600 feet of the ocean or a large body of water.
The structure
The home's structural type feeds into the required pressure for the opening.
The size of the door
Larger openings see higher loads. The door must be rated for its own width and height.
Your local building department sets the design pressure for your address. If you are unsure, ask them or the dealer before you order. The Door and Access Systems Association publishes a technical data sheet, TDS 155, on garage door wind loads.
What Applies Here
The strictest Florida garage door rule, which requires every garage door to meet a large missile impact rating, applies in the High Velocity Hurricane Zone of Miami-Dade and Broward counties, not in Leon County. Wind-borne debris requirements are more likely to apply farther south and closer to the shoreline.
That does not mean storms are no concern here. Hurricane Helene in September 2024 left about 53,000 City of Tallahassee Utilities customers and 35,000 Talquin Electric customers without power at the peak, according to the National Weather Service. Trees and limbs are a common source of damage to garage doors in Tallahassee storms.
What to Ask About a Wind-Rated Door
The rating, in pounds per square foot
Ask for the positive and negative design pressure and compare it to what your building department requires.
The Florida Product Approval number
Wind-rated garage doors sold in Florida carry a product approval. Ask for the number and the paperwork.
Whether the opener and track are part of the rated assembly
The rating applies to the door as installed, with the right track and hardware.
Insurance discounts
Clopay notes that exceeding code requirements may qualify for insurance discounts. Check with your agent first.
Wind-Rated Door Questions
It means the door has been tested and approved for a specific design wind pressure, measured in pounds per square foot. The door has to meet or exceed the pressure required for the opening where it is installed.
Building requirements depend on the address, the exposure and the size of the opening. Ask your local building department what applies to your home before you order a door.
No. A wind-load rating covers pressure from wind. An impact rating covers resistance to flying debris. Some areas of Florida require both, and the strictest rules are in Miami-Dade and Broward counties.
A wind-rated door is a complete assembly with matched track and hardware, so it is normally a door replacement rather than an add-on. A technician can look at your current door and advise.
It may. Clopay notes that exceeding code requirements can qualify for discounts. Ask your insurance agent what documentation they need.
Related Pages
New door installation, insulated doors, repair vs replace, cost guide, and emergency repair after a storm.
Thinking about a storm-rated door?
Call and tell us the size of the opening and what you are looking for. We will explain the options and quote in writing.
Call (850) 739-7022